• The surface must be professionally sanded. The floor must be dry and free of any old coatings, oil, grease, wax, silicone, sanding dust and other impurities.
• The optimal processing conditions are room temperature +15°C to + 25°C, floor temperature +15°C to +22°C, rel. humidity 40% - 65%, material temperature +18°C - + 25°C, max. wood moisture 12%, sufficiently ventilate working rooms.
• In order to prevent parquet damage, the room temperature should be set to the annual average expected for the use of the product.
• Transfer material to a LOBA varnish bucket before applying.
• Shake the contents well.
• Observe general and, if necessary, product-specific occupational health and safety regulations. Further information can be found in the GISCODE-related operating instructions which are available under www.wingis-online.de.
• This product is part of the LOBA and Wakol “Connected Systems”. The approved combinations with Wakol parquet adhesives may be found in the "Connected Systems" Matrix: www.loba.de/connected-systems

Thinner / Mixing

The product is ready for use and must not be reduced!

Application tool / application rate

LOBA oil roller Microfaser 60-80 or LOBA trowel / 30-60 ml (g)/m2, depending on the absorbency of the substrate. Equalise with LOBASAND SpecialPad beige.

Drying time

• Can be walked on after 12 hours.
• Light stress after 24 hours.
• Full Stress and coverage after 10 days.
• The floor can be covered earlier by using LOBA Cover 400, for details see the TI for the product.

Roller application:

• Prepare the substrate.
• Apply a thin layer of oil using the LOBA oil roller Microfaser 60-80.
• Allow to work for around 1 hour.
• Equalise with the single-disc machine and the LOBASAND SpecialPad beige underneath.

Roller and trowel application for areas with heavier wear:

• Apply a thin layer of oil using the LOBA oil roller Microfaser 60-80.
• Allow to work for around 1 hour.
• Equalise with a single-disc machine and the LOBASAND SpecialPad beige underneath.
• Drying overnight.
• Apply oil in sections with a LOBA trowel.
• Immediately equalise with the single-disc machine and the LOBASAND SpecialPad beige underneath.

Important information

Excess material must be completely removed during equalisation. Drying delays are possible on some exotic timbers.Keep soaked cloths, pads and other tools in closed containers. Moisten oil in combination with sanding dust, fabric cloths and so on with water or store in a sealable bucket and dispose of in a fire-safe manner, since otherwise there is a risk of self-ignition.Trowel applications are only possible with joint-sealed wooden flooring. Oil that penetrates joints will not dry completely over a long period.